Dimlux Maxi Controller

The DimLux can be used as a standard (digital) ballast in a standard system with a relay and time switch. However, using the DimLux in combination with the OptiClimate Maxi Controller will do full justice to the DimLux’ maximum performance and many options. DimLux ballasts used in combination with a OptiClimate Maxi Controller also offer many other functions and options, such as: Simulation of sunrise/sunset Asynchronous times (for example, 10 hours on and 11 hours off) An OptiClimate canopy temperature camera can be connected to the system to monitor evaporation from the crop: an excessive canopy temperature is indicative of problems with the plants’ evaporation capacity (for example, due too little water or excessive light). If the canopy temperature rises to an excessive level then the DimLux ballasts are dimmed or switched off until the temperature falls to an acceptable level: failure to lower an excessive canopy temperature would result in the plants reducing their evaporation capacity by closing the stomata, which would in turn shut down the assimilation of CO2 and photosynthesis – and halt growth. A prolonged shutdown will ultimately result in scorched foliage and cause irreparable damage to the plant’s ‘engine’ (the foliage). The canopy temperature is of greater importance to plants than the ambient temperature! A Maxi Controller equipped with all the necessary sensors (other than the CO2 sensor) (canopy temperature, ambient temperature and relative humidity sensors) can be used to calculate the vapour pressure deficit: the vapour pressure deficit is a measure of the plants’ maximum evaporation capacity (the potential water demand) An optional CO2 sensor can be connected to the Maxi Controller to control the dosage of CO2. All sensors available for the Maxi Controller are precision sensors with a high sensitivity.

Dimlux website

• CO2 Sensor and Valve Option
• Temperature Sensor Option
• Humidity Sensor Option
• Plant Temperature Camera Option
• Fantastic piece of kit!